# Heat Pump Aux Heat vs Emergency Heat: What Each Setting Means

AUX heat comes on by itself. EM HEAT is a setting you choose. Learn what each means, when each makes sense and what to tell a technician.

[Home](https://rtpheatingandair.com/) / [Blog](https://rtpheatingandair.com/blog/) / Heat Pump Aux Heat vs Emergency Heat: What Each Setting Means

AUX heat comes on by itself. EM HEAT is a setting you choose. Learn what each means, when each makes sense and what to tell a technician.

By RTP HVAC Published November 19, 2026 8 Min Read

Free, No-Obligation Estimates Manual J Load Calculations Help With Rhode Island Rebate Programs Based in Warwick, RI

You glance at the thermostat on a cold morning and see AUX lit up. A few settings over, there is a mode called EM HEAT that you have never touched. Both are backup heat, and they work very differently. This post explains what each one means, when each makes sense, and when AUX is a sign something needs a look. If you smell gas, hear a hiss, see smoke or flames, or a carbon monoxide alarm sounds, get everyone out of the house and call 911 from outside first.

## What AUX Means

AUX is short for auxiliary heat. It is the backup heat in a heat pump system, and the system turns it on by itself. Honeywell Home's support page describes it as backup heat that turns on to help the compressor. Most thermostats show AUX on the screen while it runs.

Honeywell Home's page says the backup is commonly electric heat strips or a fossil fuel source. In a dual fuel setup, where a heat pump is paired with a furnace, the backup can be the furnace. ENERGY STAR says that pairing a heat pump with a backup energy source can heat a home most efficiently when temperatures are even lower, and that a contractor can help decide how a backup system fits your home.

On most thermostats you do not control AUX directly, and you usually do not need to. The controls decide when the heat pump alone is not keeping up.

## When AUX Is Normal

Some HVAC service guides list the same few situations where AUX showing up is expected:

- Very cold weather, when the heat pump struggles to keep up on its own.

- Recovery after a setback, such as a cold house first thing in the morning after a night of lower settings.

- The defrost cycle, when the outdoor unit warms its coil to melt frost and the indoor air can feel cooler. Many systems switch on backup heat to soften that dip. Our post on [heat pump defrost mode](https://rtpheatingandair.com/blog/heat-pump-defrost-mode-steam-winter/) covers what a normal cycle looks like.

If AUX comes on during a cold snap, runs for a while, and goes off, that is the system doing its job. A Rhode Island January will bring it out more often than a mild November will.

## What EM HEAT Means

EM HEAT is emergency heat, and it is a different thing. It is a mode you select yourself. When the thermostat is in that position, Honeywell Home's page says the compressor does not run and only the emergency heat runs. Google's Nest support page makes the same split: emergency heat has to be turned on manually, while auxiliary heat can come on automatically as needed.

In plain terms, AUX is the system bringing in backup heat on its own. Depending on how the system is set up, the heat pump may keep running alongside it, or the outdoor unit may stop while the backup carries the load. A furnace backup usually works the second way, and some electric setups do too in deep cold. EM HEAT is you switching the heat pump out of the picture by hand. The thermostat may not offer EM HEAT at all if it was not set up for a system with backup heat.

## When Emergency Heat Makes Sense

Some guides describe emergency heat as a stopgap for a heat pump that has failed or cannot run, when you need heat in the meantime. Examples:

- The outdoor unit is damaged, for instance by a fallen branch or a car.

- The outdoor unit is iced over solid and stays that way for hours.

- The outdoor unit is not running at all and the house is getting cold.

In those cases, switching to EM HEAT can keep the house livable while you wait for service. Call first if you can, because some situations are better handled by having the technician tell you what to do. Some guides say to use it only when the heat pump has failed or a technician instructs it. Google's Nest page says you should not need it often.

Do not use emergency heat just because it is cold out. If the heat pump is working, AUX already adds help when it is needed.

## Why Not to Leave It On

Electric backup heat is usually a more expensive way to heat a home than the heat pump itself. With a furnace as the backup, the cost depends on fuel prices. Google's Nest support page calls running emergency heat usually expensive and inefficient. With EM HEAT on, the compressor does not run, so the backup heat does all of the heating while the setting is on.

Some guides also point out that the setting does not reset itself. If you switched to EM HEAT during a repair, look at the thermostat once the technician leaves and confirm it is back on normal heat. If you are not sure, ask them before they go.

## Signs AUX Is Running Too Much

A few patterns are worth a call:

- AUX is on in mild weather.

- AUX is on most of the day, every day, even when it is not especially cold out.

- The house never reaches the setting even with AUX running.

- The outdoor unit looks iced over or steams without stopping.

- Heating bills jump with no change in the weather.

Several things can cause this. Some guides name sizing, airflow, a stalled heat pump or aggressive thermostat settings. ENERGY STAR says properly sized equipment is essential for performance and comfort. You cannot tell which cause it is from the living room, so describe the pattern and let a technician sort it out. If frequent setbacks may be part of it, see our post on [what temperature to set a heat pump in winter](https://rtpheatingandair.com/blog/what-temperature-to-set-heat-pump-in-winter/). It covers the setting side so this post does not repeat it.

## Safe Checks Before You Call

Work through these in order. None of them involves opening panels or touching wiring.

- Read the thermostat. Is it on EM HEAT? If you did not mean to choose it, switch back to normal heat.

- Look at the outdoor unit from the ground. Is the fan turning, or is it steaming for a few minutes and then going back to normal? A fan that pauses during defrost is normal, and with a furnace as the backup the outdoor unit may sit idle while the furnace heats. If snow is piled on it, turn the system off at the thermostat first, then clear loose snow from the ground with a soft broom, on the outside of the openings only, keeping hands and the broom clear of the fan. Do not chip at ice, pour hot water on it or use a ladder. Turn the heat back on at the thermostat when you are done.

- Check the air filter. ENERGY STAR suggests inspecting, cleaning or changing filters once a month on a furnace, central air conditioner or heat pump. Turn the system off at the thermostat before you pull it, and turn the heat back on once the filter is back in.

- Check the breaker. If water has reached the outdoor unit, the indoor unit, the furnace or the electrical panel, or you would have to stand in water to reach the panel, do not touch the breaker: leave it and call. Otherwise, if it has tripped and nothing looks damaged, one reset is fine. If it trips again, leave it off and call.

Do not open the air handler, touch wiring or sensors, or work on refrigerant lines. Those need a technician.

## When to Stop and Call

Some situations are emergencies.

- Smell gas or hear a hiss anywhere in the house: get everyone out right away, then call 911 or the gas utility from outside. Do not touch the thermostat, a switch or a breaker on the way out, and do not use a phone inside.

- Carbon monoxide alarm sounding: get everyone outside, then call 911 from outside. Do not stop to touch the thermostat, a switch or a breaker, and do not go back in until responders say it is safe.

- Smoke or flames: get everyone out of the house right away and call 911 from outside. Do not stop to turn anything off. Burning smell with no smoke or flames: switch the system off at the thermostat and call for service right away. If the smell is strong or does not clear, leave the house and call 911.

- The breaker trips and trips again, or the house cannot hold a livable temperature: stop resetting it and call for service right away.

If your backup is a furnace that will not start, our post on [a furnace that is not turning on](https://rtpheatingandair.com/blog/furnace-not-turning-on/) covers the safe checks. A furnace that starts and stops is in [furnace short cycling](https://rtpheatingandair.com/blog/furnace-short-cycling-causes/).

## What to Tell the Technician

A few notes make the visit faster. Write these down while it is happening:

- What the thermostat showed: AUX, EM HEAT or neither, and when it changed.

- The outdoor temperature, and whether it was snowing, damp or freezing rain.

- How long AUX ran, and whether the house reached the setting.

- Whether the outdoor unit was running, steaming, iced or silent.

- Any recent change, such as a new thermostat, a lower overnight setting or a power outage.

- Whether you ever used EM HEAT, and for how long.

A photo of the thermostat screen and the outdoor unit helps. For a heat pump that ices up, runs backup heat all day or has stopped heating, see [heat pump repair and service](https://rtpheatingandair.com/heat-pump-repair-and-service/). If you are weighing a new system, our [heat pump installation](https://rtpheatingandair.com/heat-pumps/) page and the guide on [heat pump or furnace](https://rtpheatingandair.com/guides/heat-pump-or-furnace-rhode-island/) cover how backup heat fits in. Incentives change, so check the [rebates page](https://rtpheatingandair.com/rebates/) for the programs and sources it lists, and confirm details with the program.

RTP HVAC

Written by the RTP HVAC team in Warwick, Rhode Island, a Rooftop Power company.

## Frequently Asked Questions

### What does AUX mean on a heat pump thermostat?

AUX is short for auxiliary heat, the backup heat the system turns on by itself when the heat pump needs help or cannot keep up. Honeywell Home describes it as backup heat that turns on to help the compressor. You do not turn it on yourself.

### What is the difference between aux heat and emergency heat?

Aux heat is automatic. Depending on how the system is set up, the heat pump may keep running with it, or the outdoor unit may rest while the backup heats, which is how a furnace backup usually works. Emergency heat is a setting you choose by hand, and with it on the compressor does not run, only the backup heat does. Google's Nest support page says emergency heat must be turned on manually, while auxiliary heat can come on automatically as needed.

### When should I use emergency heat?

Mostly when the heat pump itself is not working, for example the outdoor unit is damaged, or it is not running at all and the house is getting cold, and you are waiting on service. If you are unsure, call before you switch. Some guides say to use it only when the heat pump has failed or a technician tells you to.

### Is it bad to leave my thermostat on emergency heat?

It is often an expensive way to heat, especially with electric backup. Google's Nest support page says running emergency heat is usually expensive and inefficient. The setting generally stays on until someone turns it off, so if you used it during a repair, check that the thermostat is back on normal heat afterward.

### Why is my aux heat on all the time?

Cold weather and defrost are normal reasons, but AUX that stays on in mild weather or never seems to shut off deserves a service call. Some guides link constant aux heat to sizing, airflow, a stalled heat pump or thermostat settings, and a technician has to sort out which.

### Can I use emergency heat if my heat pump is iced over?

If the unit stays iced over solid for hours, it can keep the house warm while you wait for service, but it does not fix the ice. Call first if you can. Do not chip at the ice or pour hot water on the unit. Call for service and tell the technician what you saw.

## Services in This Post

- [Heat Pump Repair and Service in Rhode Island](https://rtpheatingandair.com/heat-pump-repair-and-service/)

- [Heat Pump Installation in Rhode Island](https://rtpheatingandair.com/heat-pumps/)

- [Heating Installation and Service in Rhode Island](https://rtpheatingandair.com/heating/)

## Keep Reading

- **[What Temperature to Set a Heat Pump in Winter](https://rtpheatingandair.com/blog/what-temperature-to-set-heat-pump-in-winter/)** Heat Pumps Should you turn a heat pump down at night? ENERGY STAR and DOE guidance on steady settings, setbacks, backup heat and wall-mounted units. November 7, 2026 · 5 Min Read

- **[Heat Pump Steam in Winter: Defrost Mode Explained](https://rtpheatingandair.com/blog/heat-pump-defrost-mode-steam-winter/)** Heat Pumps White steam rising off your heat pump in winter is usually the defrost cycle. Here is how long it should last and when it points to a problem. November 7, 2026 · 5 Min Read

- **[Furnace Not Turning On: Safe Checks Before You Call](https://rtpheatingandair.com/blog/furnace-not-turning-on/)** Heating Furnace won't turn on? Work through the safe checks in order: thermostat, power switch, breaker, filter, vents and fuel. Then learn when to stop and call. November 12, 2026 · 6 Min Read

- [Heat Pump or Furnace in Rhode Island?](https://rtpheatingandair.com/guides/heat-pump-or-furnace-rhode-island/)

[Back to Blog](https://rtpheatingandair.com/blog/)

## AUX Heat Running Longer Than It Should?

Write down when AUX comes on and what the weather was doing, then call RTP HVAC at (401) 593-3983 and describe it.

[Get a Free Estimate](https://rtpheatingandair.com/contact/)
- [(401) 593-3983](tel:+14015933983)
