# What Temperature to Set a Heat Pump in Winter

Should you turn a heat pump down at night? ENERGY STAR and DOE guidance on steady settings, setbacks, backup heat and wall-mounted units.

[Home](https://rtpheatingandair.com/) / [Blog](https://rtpheatingandair.com/blog/) / What Temperature to Set a Heat Pump in Winter

Should you turn a heat pump down at night? ENERGY STAR and DOE guidance on steady settings, setbacks, backup heat and wall-mounted units.

By RTP HVAC Published November 7, 2026 5 Min Read

Free, No-Obligation Estimates Manual J Load Calculations Help With Rhode Island Rebate Programs Based in Warwick, RI

You drop the thermostat to 62 before bed, the way you did with the old furnace. By morning the house is cold, the thermostat says AUX, and the heat pump has been running flat out since 5 a.m. Heat pumps do not follow the rules you learned from furnaces and boilers. Here is how to choose a winter setting and what to avoid.

## Start With a Steady Setting

ENERGY STAR gives this advice in plain terms: unlike a furnace or boiler, heat pumps do not save energy by turning the temperature down when you are away or asleep. Its recommendation for a heat pump is to pick a comfortable temperature and leave it there.

There is no single correct number. If you are not sure where to start, try 68 for a week. Move it one degree at a time until the house feels right, then stop adjusting. People in the same house often disagree, and a number that suits one family is too warm for another.

## Why Big Setbacks Can Backfire

A furnace can usually recover from a deep setback faster than a heat pump can. A heat pump tends to raise the house temperature more gradually, so recovery from a deep overnight drop can take longer. Many systems have backup heat that comes on when the thermostat sees a large gap between the room and the setting.

DOE says that turning the thermostat back 7 to 10 degrees for 8 hours a day from its normal setting can save energy. For heat pumps, DOE notes that programmable thermostats have generally not been recommended, though some companies now sell thermostats designed for heat pumps that make setting back cost effective.

The practical reading:

- With a regular thermostat, keep the setting steady.

- If you want a nightly setback, use a thermostat made for heat pumps and ask the installer or a technician how to set the schedule.

- If you do set back, small steps tend to work better than a deep drop, and a gentle morning recovery is easier on the system than one big jump.

### What Backup Heat Means for Your Setting

Backup heat is typically electric resistance strips or a second fuel, and it is meant for the coldest days. Electric resistance backup strips typically cost more to run than the heat pump itself, so a thermostat that calls for them every morning can be a sign the setback is too deep or the system needs a look. If your thermostat shows AUX running for long stretches in mild weather, have it checked.

## Heat Mode or Auto

In winter, many people set the thermostat to Heat rather than Auto, so the system does not switch to cooling on a warm afternoon. If your thermostat is set to Auto, make sure the heating and cooling setpoints are far enough apart that it will not flip back and forth.

## Wall-Mounted Units and Mini-Splits

If your heat pump is a ductless [mini-split](https://rtpheatingandair.com/mini-splits/), the temperature sensor is usually in the indoor unit high on the wall. Warm air collects near the ceiling, so the head can read warmer than the room feels at sofa height. You may need a slightly different setting than you would use on a thermostat in a hallway. Change it a degree at a time and give the room time to respond.

## A Two-Week Trial

Rather than guessing, run a short test:

- Pick a setting you are comfortable with, in the upper 60s if you have no better idea, and leave the schedule flat.

- Hold it for a week. Note when you feel cold, which rooms lag, and whether AUX shows up on the screen.

- Adjust by one degree if you need to, then hold for another few days.

- Only after that, try a modest overnight drop if your thermostat is made for heat pumps, and check the morning recovery.

Write the setting on a sticky note near the thermostat so everyone in the house uses the same one. Frequent changes to the dial can be one reason backup heat comes on.

## If You Are Away for a Few Days

ENERGY STAR's point about not saving energy by turning a heat pump down covers time away as well as sleep. For a longer trip, ask whoever installed or services your system what they recommend, and do not shut heat off completely in freezing weather. Frozen pipes become a risk once the house gets cold enough.

## Check the Basics Too

A steady setting works only if the system can move air. ENERGY STAR suggests inspecting, cleaning or changing air filters once a month on a furnace, central air conditioner or heat pump. Keep furniture and curtains clear of indoor heads and registers, and gently brush loose snow off the outdoor unit with a soft broom, keeping hands away from the fan, so air can reach it.

## When the Setting Is Not the Problem

If your house will not get comfortable no matter what you set, the issue may be sizing, backup heat, ducts or the equipment itself. ENERGY STAR says that if winter temperatures often drop below freezing, you should ask your contractor about an ENERGY STAR certified cold-climate unit suited to your home, and that a good contractor will help with sizing and any integration with a backup heating system. Those units are tested down to 5°F.

A few signs that point to the system rather than the thermostat:

- Some rooms stay cold while others are fine.

- Backup heat runs most of the day, even in mild weather.

- The outdoor unit is iced over or steaming without stopping. Our post on heat pump defrost mode explains what is normal.

- The heat pump runs constantly and the house still loses ground.

For those, see [heat pump repair and service](https://rtpheatingandair.com/heat-pump-repair-and-service/). If you are weighing a heat pump against what you have now, our guides on [heat pump or furnace](https://rtpheatingandair.com/guides/heat-pump-or-furnace-rhode-island/) and [mini-split or central AC for an older home](https://rtpheatingandair.com/guides/mini-split-or-central-ac-older-home/) cover how ducts and backup heat decide it. Incentives change, so the [rebates page](https://rtpheatingandair.com/rebates/) lists programs and sources to check.

RTP HVAC

Written by the RTP HVAC team in Warwick, Rhode Island, a Rooftop Power company.

## Frequently Asked Questions

### What temperature should I set my heat pump to in winter?

ENERGY STAR advises picking a comfortable temperature and leaving it there. If you are unsure where to start, try a setting in the upper 60s for a week and adjust one degree at a time.

### Should I turn my heat pump down at night?

ENERGY STAR says that unlike a furnace or boiler, a heat pump does not save energy when you turn it down while you are away or asleep. DOE notes that thermostats made for heat pumps can make setbacks cost effective, so ask before you program a big overnight drop.

### Why does my heat pump use backup heat when I raise the thermostat?

A large jump in the setting can make the thermostat call for backup heat to catch up faster. Raising the setting in small steps can help avoid that on some systems, and a thermostat made for heat pumps handles it better.

### Should a heat pump be on Heat or Auto in winter?

Heat mode keeps the system in heating. Auto lets it switch between heating and cooling, which some homeowners find confusing on mild days. Either can work if your thermostat is set up for it.

## Services in This Post

- [Heat Pump Installation in Rhode Island](https://rtpheatingandair.com/heat-pumps/)

- [Heat Pump Repair and Service in Rhode Island](https://rtpheatingandair.com/heat-pump-repair-and-service/)

- [Ductless Mini-Split Installation in Rhode Island](https://rtpheatingandair.com/mini-splits/)

- [Heating Installation and Service in Rhode Island](https://rtpheatingandair.com/heating/)

## Keep Reading

- **[Heat Pump Steam in Winter: Defrost Mode Explained](https://rtpheatingandair.com/blog/heat-pump-defrost-mode-steam-winter/)** Heat Pumps White steam rising off your heat pump in winter is usually the defrost cycle. Here is how long it should last and when it points to a problem. November 7, 2026 · 5 Min Read

- **[Furnace Short Cycling: Causes and When to Call](https://rtpheatingandair.com/blog/furnace-short-cycling-causes/)** Heating Furnace starting, running a few minutes and shutting off again? Learn the usual causes, the safe checks to try first, and when to call a technician. November 7, 2026 · 5 Min Read

- **[Heat Pump Aux Heat vs Emergency Heat: What Each Setting Means](https://rtpheatingandair.com/blog/heat-pump-aux-heat-vs-emergency-heat/)** Heat Pumps AUX heat comes on by itself. EM HEAT is a setting you choose. Learn what each means, when each makes sense and what to tell a technician. November 19, 2026 · 8 Min Read

- [Heat Pump or Furnace in Rhode Island?](https://rtpheatingandair.com/guides/heat-pump-or-furnace-rhode-island/)

- [Mini-Split or Central AC for an Older Home](https://rtpheatingandair.com/guides/mini-split-or-central-ac-older-home/)

[Back to Blog](https://rtpheatingandair.com/blog/)

## Thermostat Settings Not Making Sense?

If your heat pump runs backup heat often or never seems to catch up, call RTP HVAC at (401) 593-3983 and describe what the thermostat shows.

[Get a Free Estimate](https://rtpheatingandair.com/contact/)
- [(401) 593-3983](tel:+14015933983)
